| Message: | The original manufacturer of the hydraulic manifold block made samples for 3 times, pushed the delivery for 3 times, but the samples were still not approved. There was always 0.5~1.0mm burrs in the deep hole of the hydraulic manifold block. After AAK took over, in terms of process, it abandoned the conventional route, optimized 3 points, and got the samples approved at one time.
Tom from Holland, their customer wanted to develop a hydraulic manifold block. The maximum side length of the hydraulic manifold block is 800mm, including multiple 4 × M8 threaded holes and Φ 14、 Φ 17 deep holes, and the accuracy is more than 10% higher than the conventional one. Tom knew the difficulty of this hydraulic manifold block and the importance of this customer, so he selected 2 most recognized hydraulic manifold blocks manufacturers to make samples at the same time. It took 8 weeks to sample 3 times, and there were still 0.5~1.0mm burrs in the deep holes of the hydraulic manifold blocks. The customer was not satisfied. If the next sample of the hydraulic manifold block still can not be approved, the order had to be cancelled. Within 2 days, Tom contacted more than 30 hydraulic manifold block manufacturers, and those old suppliers suggested him giving up, which made Tom very anxious.
|
my account