my account  log out
 

AAK uses a welding reamer to process the Hydraulic Manifold Block, and the single hole processing cost is 1/3 of that of the original manufacturer

Create: 02/02/2023
Expired Date:03/04/2023
Category: Hydraulic presses [Equipment&Machinery]
Message:For a hydraulic manifold block with many deep holes and great difficulty in finishing, the original hydraulic manifold block manufacturer worked on the trial order for 15 days. After 15 days of processing, the single hole processing cost increased by nearly 30%, and the production efficiency was only 1/5 of the normal. Leon understood that the processing cost was not affordable and had to change the manufacturer of the hydraulic manifold block. After AAK took over, the welding reamer with special groove and blade design was used to replace the conventional hard reamer. The linear speed was up to 680m/min, the production efficiency was increased by more than 10 times, and the processing cost of single hole position was only 1/3 of that of the original hydraulic manifold block manufacturer
City:Ningbo Zhejiang[CN] 
Location:
 Is this a real buying request?
 

return back

Copyright © 2012-2017 toextrade Inc. All rights reserved. Contact us   DeepData©