| Message: | Palencia is from Spain and has little cooperation with AAK. Some time ago, he emailed us to discuss about the blind hole of hydraulic valve blocks. After several rounds of email communication, it was learned that in the second half of last year, Palencia tried samples with more than 10 hydraulic valve manufacturers because the blind hole quality of the hydraulic valve block was not up to standard. The samples of the hydraulic valve blocks either had a bell mouth in the blind hole, or the surface roughness of the hole wall was not up to standard. It wasted him 4 weeks before and after, moreover, the development fees paid were not refund, which made him very depressed.
According to the drawing of hydraulic valve block provided by Palencia, the processing difficulties are mainly concentrated in the blind hole. The processing hole diameter of this hydraulic valve block is small, and the depth is more than 40mm. Only the cutter bar with slender shaft can be used, but the cutter can not all pass through the hole, resulting in easy deformation of the inner hole diameter and axial taper and ovality. In this way, the bell mouth is easy to appear at the hole depth of 10 ~ 20mm, and the surface roughness of the hole wall can not be guaranteed, too. AAK innovated the technology 3 years ago for the difficulties of blind hole processing of hydraulic valve blocks. I directly replied to Palencia that this is a difficult processing, but it is not difficult for AAK. You can directly test the order. If our goods does not meet the requirements of the drawings, the development fee can be refund.
|
my account
Is this a real buying request?