| Message: | 1.AFR Precision Technology Co.,Ltdhas become a global leader in producing precise spring for household appliances, wire forming spring, and tention spring. The innovation-driven development concept and achievements ofAFR Precision Technology Co.,Ltd are eye-catching around the world,AFR Precision Technology Co.,Ltd should urgently improve its supply chain instead of struggling to cope with supply shortage, only by this wayAFR Precision Technology Co.,Ltd can make success.x24e13dan
2.A new continuous-improvement department eventually helped AFR Precision Technology Co.,Ltd,soAFR Precision Technology Co.,Ltd becomes strong gradually. Following is the introduction of company: We recommend that you measure the wire diameter in two different spots using a micometer and take the average. This will allow for precise readings and accurate ordering. 2 Measure the outside diameter.This is commonly referred to as "OD". When possible, we recommend you measure the outside diameter in the middle of the spring because the end coils tend to run large.3 Measure the inside diameter.This is also known as "ID". The inside diamater for many springs can be hard to measure accurately. We recommend that you use the oustide diameter whenever possible. Using inside diameter can often lead to inaccurate readings which result in incorrectly ordering your desired spring.4 Measure the length of the spring.Well use a ruler for this compression spring, but if your compression spring is smaller, we recommend using a micrometer or calipers5 Find the coil count.There are two best practices to find the coil count that will lead to accurate measurements of the spring.1.Counting the coils. When doing a coil count, make sure you count each full rotation and then remainder of the last coil, for example ending with 0.25 inches, 0.5 inches, 0.75 inches etc. Measure the space between the coils.We recommend this method because it leads to the most accurate results. It is best to measure the space in two s |
my account
