| Message: | AAK uses the DMG five axis machining center imported from Germany, which improves the stability and accuracy by 30%. Less than 5% of the hydraulic valve block manufacturers in the domestic industry are equipped with this set of equipment. After suffering losses elsewhere, an American customer went back to AAK after 45 days to place the order for hydraulic valve blocks.
Last December, I received an inquiry from American customer Joshua about a hydraulic valve block. At that time, I was a little surprised to see the accuracy requirements of the hydraulic valve block. The accuracy was 5% higher than that of HydraForce series. This was not a small challenge, but I was still confident. The next day, I sent quotation to Joshua directly. Joshua then said that it was 12% higher compared with other hydraulic valve block manufacturers, he could not place an order with AAK. After 45 days, Joshua asked us whether the last quotation of hydraulic valve block was still valid. If the original price is maintained, he will place the order for the hydraulic valve block.
For the sincerity of cooperation, Joshua also frankly told why he moved the hydraulic valve block order to AAK. The original hydraulic valve block manufacturer made samples for two times, and the parameters of each hydraulic valve block were not very stable. Some hydraulic valve block sample had very good accuracy, while others were very poor, which wasted 3 weeks of time. Joshua also checked with other manufacturers. All of them are not confident to achieve the accuracy that is 5% higher than that of HydraForce series. Another 2 weeks were wasted again. The customer was very angry that the order has been placed for 5 weeks, but the sample of the hydraulic valve block still could not be approved. Joshua felt that only AAK can make the sample successfully at one time. Even if it is 12% more expensive, it is acceptable. Aware of Joshua's dilemma, we specially spare a high-precision DMG five axis machining |
my account
